NEWS & BLOG
Thermo Thoughts
February 1, 2012
Thermo Systems has opened its California office in Mountain Pass, just outside of Henderson, NV. The office was opened in support of a large regional project. From this office, Thermo will support existing clients in the West and Southwest. The CA team is made up of both senior staff relocated from NJ as well as new team members. Thermo Systems […]
October 1, 2011
Molycorp Minerals LLC, the world’s largest producer of rare earth oxides outside of China, has partnered with Thermo Systems to design, build, and deploy a state of the art Site Wide Automation System for their flagship Mountain Pass, CA mining operation. Leveraging 14 years of experience in automation design, chemical process engineering, power plant automation, and automation construction management Thermo […]
August 1, 2011
Thermo Systems has commenced commissioning of the plant wide process automation system serving Morphotek Pharmaceuticals new Exton, PA Pilot Plant. This state of the art Allen Bradley PLC based solution was designed, built, programmed and installed as a turn-key solution delivered by Thermo Systems LLC. The plant-wide Process Automation System (PAS) integrates WFI systems, bioreactors, kill systems, process chilled water, […]
May 1, 2011
Thermo Systems kicked off the Systems Integration design and deployment for Molycorp Minerals’ new 48MW Combined Heat and Power Plant in Mountain Pass, CA. This state of the art plant will utilize a total of four Solar Titan 130 gas turbine generators rated at altitude at approximately 12MW each. Duct fired Heat Recovery Steam Generators will produce a plant total […]
June 30, 2010
In June, Thermo Systems completed the Site Acceptance Testing for the Reef Island Energy Transfer Stations located in Manama in the Kingdom of Bahrain. Thermo Systems, under a design build contract with Tabreed Bahrain, designed, built, delivered, and commissioned a network of 13 new Allen Bradley PLC based Energy Transfer Stations serving the Reef Island development. Reef Island is a […]
July 1, 2009
The Thermo Systems team commenced commissioning of a rehabbed Stewart & Stevenson LM2500 gas turbine (pictured at left) at the Morris Energy Dartmouth Power Plant in Dartmouth, MA. Thermo has been contracted by Morris Energy to design, build, and commission the redundant PLC and SCADA system which will integrate the LM2500 with the existing power generation turbines. The Dartmouth Power […]
April 1, 2009
Thermo Systems has commenced with the design and construction of the New York University cogeneration plant automation package. New York University in lower Manhattan is expanding their existing steam and chilled water plant to incorporate cogeneration. The project entails building an underground mechanical space beneath an existing community park. The new plant will house two (2) new dual fuel Solar […]